painting-hero-4

Painting

Resolve the finish before painting

The quality of painting depends on what happens where materials meet. Consider the quality of edges and surface preparation with particular attention to raking light, sheen and the junction between walls and trim. Resolve the details that are hardest to change once products have been selected.

Explore the project plan

PROPORTION. MATERIAL. DETAIL.

A considered interior, from the first decision.

Use the quality of edges and surface preparation to build a small set of options rather than a collection of unrelated samples. View the combinations under the lighting or exposure they will have in use. Look closely at thickness, visible fixings and transitions. Write down which combination is preferred and which underlying condition could make it unsuitable.

painting--5

THE MATERIAL PALETTE

Sample finish

Compare sheen on a prepared sample rather than on a small colour chip. Use a full-size sample or detail sketch to make this decision tangible. Smaller swatches can hide the effect of a visible edge or the difference between adjacent materials. Review the example under the conditions in which the finished work will normally be seen and record what should be carried through.

Visible edges

Decide how paint should meet stained wood, tile and hardware at the room perimeter. Decide whether the meeting line should be quiet or deliberately visible. A clean detail relies on coordinating the underlying layers as well as the face of the finish. Ask who will confirm the dimensions and installation order before a material choice limits what can be done at the junction.

Surface quality

Look at patched surfaces in the intended lighting before choosing how much preparation is needed. Review which parts of this detail will receive the most wear or attention. Check that the intended finish can be cleaned and maintained in those locations. Agree how to evaluate the completed work, especially where texture, daylight or normal material variations affect how the finished surface will appear.

Resolve the details behind the finish

Agree where a test area will show both a wall finish and a trim detail.

Decide which details should be drawn or sampled before materials are ordered.

Set aside time to review a representative junction and agree what is expected where different trades meet. Use the accepted sample as a reference during the work, while allowing for natural variation where it is inherent in the material. Note how the sample should be viewed and what variation is acceptable.

YOUR NEXT STEP

Discuss the finish in context

Bring the material references and one or two details that need particular care in the painting work. Look at the samples in relation to their surroundings and establish which junctions should be resolved before committing to an order.

Discuss the finish in context